I am not too versed in GPU's however, so i am uncertain if this is acceptable or not.Īpart from this though, i have had little to no issue with the card ever since putting it in PCI-e 3.0. I can also see a difference of roughly 30-35 degrees celsius between my GPU temp, and it's junction temp. I checked my AMD adrenaline software, and the thing that comes to mind first is overheating. I've also had a few occasions where I played God of War, and the PC eventually just turned itself off, only to restart. This usually happens a few times, but 75% of the time turning it off and on again seems to just 'fix' it. It makes it to the windows loading screen, then freezes a few moments, and decides to reboot the PC. The only issue I am running into currently, is that it sometimes gets stuck in a boot loop, but then starts normally. I am assuming it is some issue with the Mobo in any case. I do not have a new CPU to try it out with unfortunately. TIP do not use voilence but a firm push is enough.įirst of all, thank you everyone for the replies.Īn update: The card works fine in PCI-e 3.0 mode. But the buyers computer would not turn on, and it turned out that the PCIE slot and the graphics card simply did not fit perfect together I think reason was the metal spacing on the back of the graphics card made the motherboard bend a little so it did not connect 100% in the PCIE slot.Īnyway try to press in the graphics card a bit hard while you turn on the pc and see what happen. ( in my case i had 2 graphics cards and sold one of them. Push in the Graphics card hard while you turn on the computer this happen 1 time for the +30 years i build computers. If one of these metal spacings is missing then it can be hard to push the graphics card correctly into hte PCIE slot.ĪNother thing you can try. so maybe remove and instert the graphics card again and push it in harder and check its in in both the front and rear end of the PCIE slot.Īlso in rare cases it can happen that people who build their own pc did not correctly install the metal spacing parts on the back of the motherboard so that the back of the motherboard is touching metal of the case. In other cases the issue can be that the Graphics card did not make good enough contact in the PCIE slot. Then its normal the computer reboot 3-4 times without anyting on the screen, be patient if this happen it will auto configure itself. DO NOT do this while the pc is on.Īlso the first time you install new hardware ( especially cpu and ram ) Oh and when your pc is turned off, try to push the PCIE cables harder into the graphics card just in case one of them is only 99% inserted. but sometimes people somehow are able to install them anyway and well then issues happen. Typical though old psu and new psu cables do not fit into the psu since the slots/pins have different shapes. Cables from one PSU is not compatible with cables from another PSU since the wiring can be different. You need to change 100% of all cables if you get a new PSU els bad things can happen. If you upgrade to a new PSU then DO NOT use the old cables in the pc. everything need to power off.Įls another thing some people do wrong is. Also turn off all other power to your screen and usb hubs and so on. When i insert the battery and boot the pc it worked. Next i removed the bios battery and left the computer without power all night. The way i fixed a similar issue years ago was to power off the computer and remove the power cable to the PSU. But in rare cases you can experience that your gpu will not show anyting on the screen since something is stuck in bios/ram.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |